Symbol Definitions; Special Characters - Extron electronics DMP 128 User Manual

Symbol Definitions

] =
Carriage return/line feed
} =
Carriage return (no line feed)
• = Space character
E or W = Escape key
X6)
= Gain and trim control
=
X6! Level value:
Mic/line input gain controls ( A )
Input pre-mixer gains ( B )
Virtual returns, pre-mixer gains ( C )
Output trim control (post-mixer trim) ( D )
Output volume controls ( E )
X6$
= Mute status
X6%
=
Group master group number
X6^
=
Group fader setting
X6&
= Group fader increment
X6*
= Group fader soft limit
X6(
= Group type
X7)
= Personal identification number (PIN)
X7!
= Protected configuration status

Special Characters

The HTML language reserves certain characters for specific functions. The device will not
accept these characters as part of preset names, the device's name, passwords, or locally
created file names.
The DMP 128 rejects the following characters:
{space (spaces are OK for names)} + ~ , @ = ' [ ] { } < > ' " ; : > \ ?
See table 1 on page 148.
See table 2 beginning on page 150.
-18.0 dB to +80 dB, (1868 to 2848 ) in 0.1 dB increments.
-100.0 dB to +12.0 dB, (1048 to 2168) in 0.1 dB increments.
-100.0 dB to +12.0 dB, (1048 to 2168) in 0.1 dB increments.
- 12.0 dB to +12.0 dB, (1928 to 2168) in 0.1 dB increments.
-100.0 dB to +0.0 dB, (1048 to 2048 ) in 0.1 dB increments.
0 = unmute
1 = mute
01 to 32
dB value, in 0.1 dB increments using a 10x multiplier and negative
numbers, but not decimal places. The valid range depends on
the type of gain block that is assigned to the group number (X6%)
specified in the command:
A = -180 to 800 -18.0 dB to +80.0 dB)
B = -1000 to 120 (-100.0 dB to +12.0 dB)
C = -1000 to 120 (-100.0 dB to + 12.0 dB)
D = -120 to 120 (-12.0 dB to +12.0 dB)
E = -1000 to 000 (-100.0 dB to +0.0 dB)
Leading zeros are ignored.
NOTE:
dB value, in 0.1 dB increments, to raise or lower a group fader
dB value, in 0.1 dB increments. The valid range X6^ must be within
the range for the gain block grouped in X6% .
6= gain
12 = mute
Four numeric digits, default = 0000
0 = no protected configuration saved
1 = protected configuration saved
DMP 128 • SIS Programming and Control 142