Dante Controller Software Installation; Dante Network Audio Setup - Extron electronics DMP 128 User Manual

Dante Controller Software Installation

Dante Network Audio Setup

AT 1 2 3 4
1 2 3 4 5 G
LINE PHONE
5 6 7 8
11 12 13 14 15 G
L E
The DMP 128 AT uses Dante Controller for Windows from Audinate to select and route
inputs and outputs for all connected DMP 128 ATs and other Dante-compatible audio
devices.
Download and install the latest version of Dante Controller for Windows from the included
software DVD or from the Dante Controller product page at
The following procedure is recommended for configuring DMP 128 AT devices on a Dante
network. When configuring multiple DMP 128 AT models, follow this procedure for each
device, connecting them to the host computer one at a time.
K
6 7 8 9 10 G
1 2 3 4
RS-232
16 17 18 19 20 G Tx Rx G EXP LAN
F G H I
Figure 82. Rear Panel, AT Switch (
NOTE: A connection to both the Dante (AT) Ethernet switch and the DMP 128 LAN
port is required for this setup.
• If the control computer has only one Ethernet port, connect it to a rear panel AT
port (see figure 82,
( ) to an unused AT port (
I
• Alternately use an Ethernet switch to connect the control computer to both the
LAN and AT ports.
1. Connect the control computer to an AT (Dante) port
on the DMP 128. Also connect the control computer
to the DMP 128 LAN port.
2. Start DSP Configurator in Live mode (see
Selecting Live Mode and Pushing or Pulling
Data on page 91).
3. From the DSP Configurator menu bar, select
Tools > Device Settings (see figure 83, right).
RESET
J
)
K
). Then connect a short Ethernet cable from the LAN port
K
).
K
DMP 128 • Dante Installation and Operation
www.extron.com .
Figure 83. Tools, Device Settings
114