Software Installation; Software Installation Overview - Extron electronics DMP 128 User Manual

Digital matrix processor
Hide thumbs Also See for DMP 128:
Table of Contents

Advertisement

Software Installation

The DMP 128 has no front panel hardware controls. To configure and operate the DMP 128,
use a PC running Microsoft
Both DSP Configurator and Dante Controller are available from the DMP 128 product page
on the Extron Website.
Signal processing for the DMP 128 can also be controlled using the Extron Simple
Instruction Set (SIS) commands with HyperTerminal or DataViewer (see
and Control
from Audinate.
See
page 130 for additional details to connect via the LAN ports.

Software Installation Overview

DSP Configurator and Dante Controller (DMP 128 AT models only) must be installed to
configure the device and route transmit and receive channels. Download and install both
software programs in the order they are listed below:
1.
2.
3.
4.
5.
Windows
®
Dante Controller for Windows from Audinate is required by all DMP 128 AT models
to select and route digital inputs and outputs to and from connected Dante-compatible
devices on the same network and to rename connected devices.
DSP Configurator is used to customize signal processing for the input channels of all
DMP 128 models.
on page 129). Digital signal routing can only be done using Dante Controller
Rear Panel Features and Cabling
Download Dante Controller for Windows from the Extron Website (see
Controller Software Installation
Install Dante Controller.
Rename each device as it is placed on the network (when there are multiple
DMP 128s on the network) (see
NOTES:
To avoid confusion, rename each device with a unique identifier.
To simplify renaming, connect only one device to the network at a time. As
each device is renamed, it can remain on the network.
Download DSP Configurator (see
on page 15).
Install DSP Configurator.
7 or newer and the following software programs:
®
on page 6, and
Ethernet (LAN) Port
on page 114).
Rename a Dante Device
Downloading and Installing DSP Configurator
DMP 128 • Software Control
SIS Programming
on
Dante
on page 121).
13

Advertisement

Table of Contents
loading

Table of Contents