Extron electronics DMP 128 User Manual page 126

When the network scan is compete, Dante Controller opens in Network View.
Dante
Receivers
Figure 89. Dante Network View
Receivers, representing Dante device inputs, are on the left side running vertically.
Transmitters, representing Dante device outputs, are along the top running horizontally. The
connection points form a large matrix in the center of the screen.
The name initially shown in the first column is extracted from the Dante interface of the
connected device. The DMP 128 AT expansion inputs are Dante receivers and labelled
EXP_In-01 to EXP_In-56 (or the maximum available from each connected device).
The output names are labelled from Output-01 to Output-08 to mirror the DMP 128
line outputs, and from EXP_Out-01 to EXP_Out-08 that correspond to the DMP 128
expansion outputs and EXP_Out-09 to EXP_Out-16 that correspond to the DMP 128
virtual returns 9 to 16.
Dante provides a way to rename the connected device and to re-label each input and
output (Dante Controller does not automatically use the DMP 128 AT device name). Follow
the setup procedure (see
names identical or at least as similar as possible to avoid confusing device names during
operation. Inputs and outputs can also be renamed as necessary before proceeding.
Dante Controller Naming Conventions:
• Device labels follow Domain Name System (DNS) hostname rules. Legal characters
are A-Z, a-z, 0-9, and dash or hyphen (-). Device labels must begin with a letter.
• Dante Tx and Rx labels can be up to 30 characters in length. Label comparisons
are not case-sensitive; "OUTPUT01" and "output01" are treated the same.
Unicode and non-roman characters are not supported.
• Tx channel labels can use any character except equals (=), period (.), or '@'. Tx
channel labels must be unique on a device but do not need to be unique on the
network. On the network, channel IDs are prefaced with the device ("channel01_
DMP128-01", or "channel01_DMP128-07").
• Rx channel labels follow the same rules as Tx channel labels.
Dante Network Audio Setup
Dante
Transmitters
Connection
Points
on page 114) keeping both
DMP 128 • Software Control 120