Extron electronics DMP 128 User Manual page 165

On password-protected connections, there are two levels of protection: administrator and
user. Administrators have full access to the passwords and firmware upgrade pages. Users
have view only access.
• Ethernet connection to the device, either entering SIS commands
(see SIS Programming and Control
DSP Configurator Program, (see
is password-protected.
• Connection via any RS-232 port is not password-protected.
IP Settings panel
The fields in the IP Settings panel provide a location for viewing and editing settings
unique to the Ethernet interface. After editing any of the settings on this page, click Submit
at the bottom of the panel.
Unit Name field
The Unit Name field contains the name of the device. This field can be changed to any
valid name, up to 24 alphanumeric characters.
NOTE: The following characters are invalid in the matrix name:
+ ~ , @ = ' [ ] { } < > ' " ; : > \ and ?.
DHCP radio buttons
The DHCP On button directs the device to ignore any entered IP addresses and to obtain
its IP address from a Dynamic Host Configuration Protocol (DHCP) server (if the network
is DHCP capable). The DHCP Off button turns DHCP off. Contact the local system
administrator for additional information on your network.
IP address field
The IP Address field contains the IP address encoded in the flash memory of the
connected device.
Valid IP addresses consist of four 1-, 2-, or 3-digit numeric subfields separated by dots
(periods). Each field can be numbered from 000 through
total per field, are optional. Values of 256 and above are invalid.
The factory-installed default address is 192.168.254.254, but if this conflicts with other
equipment at the installation site, change the IP address to any valid value.
NOTE: IP address changes can cause conflicts with other equipment. Only local
system administrators should change IP addresses.
Gateway IP address field
The Gateway IP Address field identifies the address of the gateway to the mail server to
be used if the device and the mail server are not on the same subnet.
The gateway IP address has the same validity rules as the system IP address.
Subnet mask field
The Subnet Mask field determines whether the device is on the same subnet as the mail
server when setting up a subnet.
on page 129) or using the Extron
DSP Configurator Program Basics
. Leading zeroes, up to 3 digits
255
DMP 128 • HTML Operation
on page 18),
159