Extron electronics DMP 128 User Manual page 63

Automix Groups
Assigning individual automix channels to groups allows you to see and adjust all channels
assigned to the group on one page. The automix group dialog provides details of all
grouped and ungrouped inputs including the automix settings of each channel or mic. This
provides an overview of all channels in the selected group at a glance. Individual settings
can be changed without leaving the groups dialog. You can also select all Ungrouped
items and see the channels currently unassigned to a group.
Figure 36. Automix Groups Dialog
To Configure an Automix Group:
A channel must first have an active automix block before it can be included in an automix
group.
1. Insert an AM processing block in the desired channel. Either:
Right-click the AM block and select Insert Automixer.
•
Double-click the AM block and select Automixer.
•
2. Double-click the inserted AM block to open it.
3. Select the group number from a range of 1 through 8.
4. Set the parameters for the channel.
5. Repeat steps 1 through 3 for all channels in the automix group.
6. Open any AM block and click Select AM Group Details to open the automix group
configuration page.
7. Set NOM (the maximum number of gated mics) for the selected group.
8. Test the system and make adjustments as needed.
Adjustments are made to individual automix channels using the rows by opening each
individually, or globally to all channels using the AM group details page. Observe the
Gate Status indicators to verify that channels gate on properly.
The AM Group Details dialog provides details of all grouped and ungrouped inputs including
the automix settings of each channel or mic. This allows viewing of all channels in the
selected group at a glance to provide an overview of the group. Individual settings can be
changed without leaving the groups dialog.
DMP 128 • Software Control 57