Extron electronics DMP 128 User Manual page 121

4. In the Unit Name: field, enter a descriptive name for the DMP 128 (typically the device
name and location) to enable easy identification on the network (see figure 84,
1 1
DMP128-ConfRoom1
Unit name can be up to 24 characters drawn from the
alphabet (A-Z), digits (0-9), and minus sign/hyphen (-).
No spaces are permitted and it is not case sensitive.
The rst character must be an alpha character. The last
character must not be a minus sign/hyphen.
3 3
Figure 84. Device Settings - Unit Name
5. Click Apply ( ).
2
6. Click OK to close the dialog box (
7.
Open the Dante Controller (see
8. From the Dante Controller menu bar, select Device > Device View (see
Dante Device on page 121).
9. Choose the device. The DMP 128 appears as DMP128, plus the last six digits of the
Dante MAC address.
NOTE: Connect DMP 128 units to the Dante network one at a time to easily
identify which one is being named. To confirm the proper device, compare the
Dante MAC address printed on the rear panel of the unit with the MAC address
shown in figure 85.
10. Select the Device Config tab in Dante Controller.
11. Rename the device to match the DSP 128 name given in DSP Configurator (see step 4
above) and press <Enter>.
12. Select Yes to confirm the new name.
13. To connect additional DMP 128s, repeat this procedure with the next device.
2 2
).
3
Start Dante Controller
on page 119).
DMP 128 • Software Control
).
1
Rename a
115