Software-Based Configuration And Control; Configuration And Control: An Overview - Extron electronics IPCP Pro 250 User Manual

Software-Based
Configuration and
Control
This section of the guide is divided into the following topics:
•
•
•
•

Configuration and Control: an Overview

An IPCP must be configured before use in order to recognize and accept commands
and pass them on to the controlled devices. It can be configured and controlled via a
host computer connected to the same network as the control processor. See
connectors and LEDs
connect the control processor to the network.
•
•
Configuration and Control: an Overview
Basic Setup Steps: a Guide to this Section and Other Resources
Downloading the Software and Getting Started
Troubleshooting
starting on page 16 for details about LAN port and cabling to
Configure the control processor by using the Global Configurator software in
GC Professional or GC Plus mode. See the Extron
and software requirements.
The default Web pages embedded within the control processor provide a means
to view general hardware information, network settings, and, if configured, project
information. The embedded Web pages can also be used to update the IPCP firmware.
You cannot configure the control processor via the embedded Web pages.
IPCP Pro Series • Software-based Configuration and Control
LAN (IP)
website for full system hardware
25