Sis Command And Response Table For Dsp Mix-Point And Level Control - Extron electronics DMP 128 User Manual

sis command and response table for DsP Mix-point and Level control

Setting the level of a mix-point requires the mix-point address and level value. Making a
connection between a mix-point input and output requires the mix-point be unmuted.
command
Audio level control, and mix-point selection
notE: The command format is the same, regardless of the control or mix-point to be set; the acceptable adjustment
range of the main mix-points is -35 dB to +25 dB, in
All responses are shown with the DMP 128 in Verbose mode 2 or 3.
Set a mixpoint trim or gain
Example 1 (Input 1 to
Virtual Send A gain):
Example 2 (mix-point
gain):
Read a mix-point level
Example 1
Input 11 to Output 8:
Example 2
Input 3 to Output 4:
Audio mute
notE: All responses are shown with the mixer device in Verbose mode 2 or 3.
Audio mute
Example:
Input 4 to Output 2:
Audio unmute
Read mute status
X6)
= Mix-point select
notEs:
X6!
= Signal level value in dB
X6$
= Mute status
ascii command response
(host to device) (device to host)
E X6) X6! }
G * AU DsG
E }
G20009 2040AU DsG20009*2040
*
E }
G20001*2213AU DsG20001*2213
E X6) }
G AU DsG
E }
G21007AU DsG21007*2103
E }
G20203AU DsG20203*2140
E X6) }
M *1AU DsM
E }
M20301*1AU DsM20301*1
E X6) }
M *0AU DsM
E X6) }
M AU DsM
additional
description
0
.1 dB increments.
X6) X6!]
*
Set trim or mix control
a value of
]
Set the In 1 to Virtual Send A
gain to a value of -0.8 dB.
]
Mix +16.5 dB of input 1 into
output 2.
X6) X6!]
*
Mixpoint
X6!
of dB.
]
Mix-point In 11 to Output 8 is
set to a value of +5.5 dB.
] +9.2 dB of In 3 is mixed to
output 4.
X6) ]
*1
Mute mix-point
]
Mute mix-point input 4 to
output 2.
X6) ]
*0
Unmute mix-point
X6) X6$] X6$
* 0
:
= mute on (mute).
See tables 3-10 on pages 175-197.
See table 2 on page 148.
0 1
= unmute = mute
DMP 128 • Reference Information
X6)
to
X6!
dB.
X6)
is set to a value
X6)
.
X6)
.
1
= mute off (unmute),
173