An Error Message Is Displayed On The Lcd - Canon MX360 Seires On-Screen Manual

An Error Message Is Displayed on the LCD

Advanced Guide
> Troubleshooting
U304
An Error Message Is Displayed on the LCD
If an error message is displayed on the LCD, take the corresponding action described below.
Message
Check ink
U051/U052/U053/U059
Check ink
U075/U076
Check ink
U140
Check ink
U150
Check ink
U162
> An Error Message Is Displayed on the LCD
The FINE Cartridge may not be installed properly,
or the Cartridge may not be compatible with this
machine.
Open the Scanning Unit (Cover) and install the
appropriate FINE Cartridge. After that, push the Ink
Cartridge Locking Cover until it clicks into place,
then close the Scanning Unit (Cover).
If the error is not resolved, the FINE Cartridge may
be damaged. Contact the service center.
Make sure that each FINE Cartridge is installed in
the correct position.
Routine Maintenance
Appropriate FINE Cartridge is not installed.
Printing cannot be executed because the FINE
Cartridge is not compatible with this machine.
Install the appropriate FINE Cartridge.
If you want to cancel printing, press the machine's
Stop button.
Routine Maintenance
The FINE Cartridge cannot be recognized.
Replace the FINE Cartridge.
If the error is not resolved, contact the service
center.
The ink may have run out.
The function for detecting the remaining ink level
will be disabled since the ink level cannot be
correctly detected.
If you want to continue printing without this
function, press the machine's
least 5 seconds.
Canon recommends to use new genuine Canon
cartridges in order to obtain optimum qualities.
Please be advised that Canon shall not be liable
for any malfunction or trouble caused by
continuation of printing under the ink out condition.
Note
If the function for detecting the remaining ink
level is disabled,
LCD.
Routine Maintenance
Since the information contained in the fax
may be lost if it is printed in this condition, the
received fax will not be printed and will be
stored in the machine's memory until the ink
cartridge is replaced. You must manually
print out faxes that were stored in the
memory. You can change the setting so that
the received fax is forcibly printed out instead
of being stored in the memory, but all or part
of the fax information may not be printed
because of the ink out condition.
Seite 801 von 922 Seiten
Action
Stop button for at
is displayed on the