An Error Message Is Displayed On The Lcd - Canon PIXMA MX320 Manual

An Error Message Is Displayed on the LCD

>
Advanced Guide Troubleshooting
An Error Message Is Displayed on the LCD
If an error message is displayed on the LCD, take the corresponding action described below.
Message
Check ink
U051/U052/U053/U059
Check ink
U075/U076
Check ink
U140
Check ink
U150
Check ink
U162
Check ink
U163
> An Error Message Is Displayed on the LCD
The FINE Cartridge may not be installed properly, or the
Cartridge may not be compatible with this machine.
Open the Scanning Unit (Cover) and install the appropriate
FINE Cartridge.
If the error is not resolved, the FINE Cartridge may be
damaged. Contact the service center.
Make sure that each FINE Cartridge is installed in the correct
position.
Routine Maintenance
The FINE Cartridge may not be compatible with this
machine.
Install the FINE Cartridge compatible with this machine.
Routine Maintenance
The FINE Cartridge may not be installed properly.
Open the Scanning Unit (Cover) and install the appropriate
FINE Cartridge.
If the error is not resolved, the FINE Cartridge may be
damaged. Contact the service center.
Ink may have run out.
The function for detecting the remaining ink level will be
disabled since the ink level cannot be correctly detected.
If you want to continue printing without this function, press
the Stop button for at least 5 seconds.
Canon recommends to use new genuine Canon cartridges
in order to obtain optimum qualities.
Please be advised that Canon shall not be liable for any
malfunction or trouble caused by continuation of printing
under the ink out condition.
Note
If the function for detecting the remaining ink level is
disabled,
Routine Maintenance
Since printing in this condition may cause the contents
of the fax to be lost, the machine stores received faxes
in memory without printing until the FINE Cartridge is
replaced. Print the fax stored in memory manually after
replacing the FINE Cartridge. You can set the machine
to print received faxes forcibly without storing them in
memory, but a part of contents or all contents of the fax
may not be printed.
Ink has run out.
Replace the ink cartridge and close the Scanning Unit
(Cover).
If printing is in progress and you want to continue printing,
Stop button for at least 5 seconds with the ink
press the
cartridge installed. Then printing can continue under the ink
out condition.
The function for detecting the remaining ink level will be
disabled.
Replace the empty ink cartridge immediately after the
printing. The resulting print quality is not satisfactory, if
printing is continued under the ink out condition.
Action
is displayed on the LCD.
Page 704 of 817 pages