Changing The Machine Operation Mode - Canon MX360 Seires On-Screen Manual

Changing the Machine Operation Mode

Advanced Guide
> Changing the Machine Settings
Changing the Machine Operation Mode
P035
Changing the Machine Operation Mode
If necessary, switch between various modes of machine operation.
The procedure for configuring Custom Settings is as follows:
Custom Settings
Open the printer driver setup window
1.
Make sure that the machine is on, and then click Custom Settings on the
2.
Maintenance tab
The Custom Settings dialog box opens.
Note
If the machine is off or bi-directional communication is disabled, a message may appear
because the computer cannot collect the machine status.
If this happens, click OK to display the most recent settings specified on your computer.
If necessary, complete the following settings:
3.
Prevent paper abrasion
The machine can increase the gap between the print head and the paper during high-density
printing to prevent paper abrasion.
Check this check box to use this function.
Align heads manually
Usually, the Print Head Alignment function on the Maintenance tab is set to automatic head
alignment, but you can change it to manual head alignment.
If the printing results are unsatisfactory even after you execute automatic head alignment, see "
Aligning the Print Head Position
Check this check box to perform the manual head alignment. Uncheck this check box to perform the
automatic head alignment.
Ink Drying Wait Time
You can set the length of the machine rest time until printing of the next page begins. Moving the
slider to the right increases the pause time and moving the slider to the left decreases the time.
If the paper gets stained because the next page is ejected before the ink on the printed page dries,
increase the ink drying wait time.
Reducing the ink drying wait time speeds up printing.
Apply the settings
4.
Click OK and when the confirmation message appears, click OK.
The machine operates with the modified settings hereafter.
> Changing Machine Settings from Your Computer
," and execute manual head alignment.
Seite 797 von 922 Seiten
>
Page top