Canon MX360 Seires On-Screen Manual page 766

Bluetooth settings Screen
When a model other than MX420 series is used, whatever appears in place of "MX420" becomes
the model name use.
Ex:
When you select MX420 series-2, the printer name displayed on the Bluetooth device is Canon
MX420 series-2.
The initial value is set to MX420 series-1.
Graphic LCD
Text LCD
Access refusal setting/Access refusal Screen
When you search from a Bluetooth device, you can enable or disable the display of the printer
name.
ON
Disables searching from a Bluetooth device.
OFF (Default setting)
Enables searching and printing from a Bluetooth device.
Security settings Screen
Enable
Selecting Enable allows you to choose either of the security modes below.
Mode 3(recommended)
This mode is activated on link level enforced security.
The passkey will be required when a Bluetooth device communicates with the printer.
Normally select this mode.
Mode 2
This mode is activated on service level enforced security.
The passkey will be required when printing through the Bluetooth communication.
After setting the security mode, we recommend making a trial print through Bluetooth
communication. If printing does not start, change the security mode and try again.
Setting a passkey will prevent unwanted access from other Bluetooth devices. You can
change the passkey on the Change passkey/Passkey screen.
Disable (Default setting)
When you register the printer, you are not required to input a passkey.
Change passkey/Passkey Screen
When you select Enable on the Security settings screen, you are required to set a passkey to
register the printer on other Bluetooth devices.
After you change the passkey, you may be asked to input the passkey on the Bluetooth devices you
were able to print from before the passkey was changed. In this case, input the new passkey.
Seite 766 von 922 Seiten