Printer Fd Registration Adjustment - Konica Minolta 7115 Service Manual

(4)

Printer FD Registration Adjustment

Requirement
B
4022D502AA
Specifications
10 ± 1.5 mm
NOTES
• This adjustment is made when the PH Unit has been replaced.
• Load the 1st Tray with A4 or 8-1/2 × 11 paper.
<Adjustment Procedure>
1. Enter the Adjust mode.
2. With "AJ-" shown on the Display, enter the code number "12" from the Key Pad.
3. Press the PAPER SIZE to select the 1st Tray.
4. Press the START.
Then, a test print will be produced.
5. Check to see if width B on the test print falls within the specified range.
If width B falls outside the specified range, perform the following steps to make an
adjustment.
6. With "AJ-" shown on the Display, enter the code number "2" from the KEYPAD and
press the START to enter the "Printer FD Registration Adjustment" mode.
7. Press the CLEAR to clear the current setting value.
8. Enter the new setting value from the KEYPAD and press the START to validate the
entry.
Adjustment Instructions
If width B on the test print is longer than the specifications, decrease the setting value.
If width B on the test print is shorter than the specifications, increase the setting value.
If a single adjustment procedure does not successfully bring width B into the specified
range, repeat steps 5 though 7.
• Adjust so that width B on the test print produced
falls within the specified range.
Mode Code No.
Adjust 2
D-56
Setting Range
67 to 133, 1 step:
Approx. 0.19 mm