Service Error Code; Causes And Remedies For Service Error Codes - Canon iR1200 Series Service Manual

Chapter 14
#084 [RX]
Cause:
Remedy:
#995 [TX/RX]
Cause:
Remedy:
Cause:
Remedy:

14.2.3 Service Error Code

14.2.3.1 Causes and Remedies for Service Error Codes

The causes and remedies for service error codes are as follows:
##100 [TX]
Cause:
Remedy:
Cause:
Remedy:
14-16
T-14-25
The other party is not equipped with a password function for
ITU-Tcompliant selective polling reception
Bit 50 of DIS received from the other party is '0'. Cause:
Use selective polling that does not use a password.
T-14-26
Memory transmission reservation clear/memory
reception image clear
In the case of transmission, the user canceled the memory
transmission reservation.
Transmit once again.
In the case of reception, the user deleted the image that had been
received in memory reception.
Ask the operator of the other party to transmit once again.
T-14-27
The number allowed for retransmission of the procedure
signal was exceeded during transmission
The transmission level is too low, and the other party cannot
receive NSS, TSI, DCS, TCF, or the training signal correctly.
Increase the transmission level so that the other party may receive
the signal correctly.
After transmission of TCF immediately before the image signal,
the other party malfunctioned because of an echo.
1. Ask the operator of the other party to provide echo remedy 2
2. Using a manual call, press the Start button after hearing the 1st
DIS from the other party.
3. To prevent response to the 1st DIS from the other party, put a
relatively long pause to the telephone number when registering an
auto dialing number.
0006-3533