[Bit 7]
Use it to impose or not impose restrictions on user settings. If set to '0', certain items cannot be set by the user,
depending on the country setting. If set to '1', on the other hand, all items may be set by the user, regardless of the
country setting.
#SSSW-SW02: network connection conditions setting
Bit
0
1
2
3
4
5
6
7
[Bit 0]
Use it to specify whether or not to put the machine in standby state if the memory clear list is not generated when the
power is turned on after an error has occurred (e.g., running out of paper).
If set to '1', the machine will generate a memory clear list and enters standby state when the image data is cleared and
the power is turned on.
If set to '1', moreover, the following takes place:
1. The alarm sounds, and the machine waits for correction; specifically,
a. The LCD indicates 'CHECK PRINTER'.
b. The machine will not start reception operation in response to arrival of data.
2. When an appropriate correction is made, the machine will automatically generate a memory clear list. If an error
(e.g., jam) occurs during output, the machine goes back to 1. above.
If set to '0', on the other hand, the machine will sound the alarm and enters standby state.
#1 SSW-SW03: echo remedy setting
Function
start-up at memory clear list output
fault
not used
not used
not used
not used
not used
not used
not used
T-15-6
1
0
prohibit
do not prohibit
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Chapter 15
Factory
setting
0
15-13