Canon iR1200 Series Service Manual page 392

Chapter 14
##763 [TX]
Cause:
Remedy:
##764 [TX]
Cause:
Remedy:
Cause:
Remedy:
##765 [TX]
Cause:
14-36
T-14-74
In ECM transmission, the allowed number of procedure
signal retransmissions was exceeded or a T5 time-over
(60 sec) condition occurred after transmission of PPS-
EOM
The page buffer of the other party is full or is engaged; as such,
although RNR was received after transmission of PPS-EOM and
then RR was transmitted, no significant signal was received
correctly thereafter.
1. Start G3 mode, and transmit once again (Prohibit the ECM
mode).
2. Decrease the transmission start speed.
3. Record the protocol on a DAT or MD, and have it analyzed by
the local Canon office and/or Technical Center.
T-14-75
In ECM transmission, the allowed number of
procedure signal retransmissions was exceeded after
transmission of PPS-EOM
The line condition is poor; as such, although PPR was received 4
times after transmission of PPS-EOM and then CTC was
transmitted, the other party could not receive it correctly.
Increase the transmission level so that the other party may receive
CTC correctly.
The line condition is poor; as such, although PPR was received 4
times after transmission of PPS-EOM and then CTC was
transmitted, no significant signal was received correctly
thereafter.
Ask the operator of the other party to increase the transmission
level so that the signal may be received correctly.
T-14-76
In ECM transmission, no significant signal can be
received after transmission of PPS-EOP, and the
allowed number of procedure signal re-transmissions
was exceeded
The line condition is poor, and the other party cannot receive PPS-
EOP correctly.