Canon iR1200 Series Service Manual page 368

Chapter 14
#005 [TX/RX]
Remedy:
#009 [RX]
Cause:
Remedy:
Cause:
Remedy:
#011 [RX]
Cause:
Remedy:
Cause:
Remedy:
#012 [TX]
Cause:
Remedy:
#018 [TX]
Cause:
Remedy:
Cause:
Remedy:
Cause:
14-12
Initial identification (T0/T1) time-over
Provide echo remedy 1.
T-14-12
Paper has jammed or the paper has run out
The paper has run out.
Set new paper.
A paper jam has occurred.
Remove the paper jam.
T-14-13
Polling reception error
There is no original in the other party.
Ask the operator of the other party to set the original correctly.
Transmission was attempted, and polling reception was started because
the document was not set correctly.
Set the original correctly to transmit.
T-14-14
The other party has run out of paper
The other party has run out of paper.
Ask the operator of the other party to set paper.
T-14-15
Auto dialing transmission error
The tone/pulse setting is wrong.
Make the correct tone/pulse setting.
The connection time for the line is too long.
1. When registering an auto-dial number, put a relatively long pause at
the end of the telephone number to delay the start of the T0 timer.
2. Increase the T0 timer setting to prevent a time-over condition.
The line of the other party was engaged.