Service Mode Table; Bit Switch Settings - Canon iR1200 Series Service Manual

Chapter 15

15.2 Service Mode Table

15.2.1 Bit Switch Settings

A bit switch consists of 8 bits, used for registering/setting an item. The switch is configured as follows, and each bit
is always either '0' or '1' :
Do not change service data marked "not used" for its initial setting.
#SSSW-SW01: error/copy control
Bit
0
1
2
3
4
5
6
7
[Bit 0]
Use it to specify whether or not to generate a service error code. If set to '1', a service error code will be indicated on
the report.
[Bit 1]
Use it to specify whether or not to generate an error dump list. When set to '1', an error dump list will be attached to
an error TX report or a RX report generated in the event of an error.
15-12
SW01 0
Function
service error code
error dump list
not used
not used
not used
not used
not used
user setting restriction
0 0 0 0 0
F-15-9
T-15-5
1 0
output do not output
output do not output
- -
- -
- -
- -
- -
do not impose impose
0 0
Factory setting
0
0
0
0006-2856