Numeric Parameter Setting - Canon iR1200 Series Service Manual

Chapter 15
##103, ##106, ##107, ##201, ##793
008 V.34 modulation speed upper limit
Use it to set an upper limit to the modulation speed (baud rate) for the V.34 primary channel.
009 V.34 data speed upper limit
Use it to set an upper limit to the data transmission speed for the V.34 primary channel
between 2.4K and 33.6K bps in increments of 2400 bps. (0: 2.4K to 13: 33.6K bps).
010 pseudo CI signal
Use it to set a frequency for the pseudo CI signal.
At times, certain types of external telephones fail to ring while fax/tel switch-over takes
place. If so, change the frequency of the pseudo CI signal.

15.2.3 Numeric Parameter Setting

No.
2
3
4
5
6
9
10
11
13
15
16
17
18
19
15-26
Item
RTN transmission condition (1)
RTN transmission condition (2)
RTN transmission condition (3)
NCC pause length (pre-ID code)
NCC pause length (post-ID code)
number of digits of telephone numbers in
comparison between transmitting and
receiv-ing machine
line connection identification time length
T.30 T1 timer (for reception)
T30.EOL timer
hooking detection time length
time to tentative response at time of fax/tel
switch-over
pseudo RBT signal pattern ON length
pseudo RBT signal pattern OFF time length
(short)
pseudo RBT signal pattern OFF time length
(long)
T-15-25
Range of settings
1 to 99%
2 to 99 times
1 to 99 lines
0 to 60 sec
0 to 60 sec
0 to 20 digits
0 to 9999 (10ms)
0 to 9999 (10ms)
500 to 3000 (10ms)
0 to 999 (10ms)
0 to 9 sec
0 to 999 (10ms)
0 to 999 (10ms)
0 to 999 (10ms)
Initial setting
10
15
12
4
4
6
5500
3500
1300
120
4
100
0
200
0006-3019