Control Panel Pcb; Power Supply Pcb; Analog Processor Pcb; Sensor Pcb - Canon iR1200 Series Service Manual

3.1.5 Control Panel PCB

Key Detection and LCD/LED Drive
The keys are monitored, and the LCD and LEDs are driven.
LCD Function
The LCD consisting of 2 lines of 20 characters is controlled according to the display signals from the image processor
PCB.
Serial Communication Control
The state of the control keys is monitored based on serial communications with the image processor PCB. LCD and
LED drive data are received.

3.1.6 Power Supply PCB

Switching Regulator
The following is generated using power from the power outlet for loads: +24 DC, +12 VDC, +5 VSDC, +5 VDC,
+3.3 VSDC, +3.3 VDC.

3.1.7 Analog Processor PCB

The analog image data read by the contact sensor is converted into digital image data and sent to the ASIC of the
image processor PCB.

3.1.8 Sensor PCB

The signals from the ADF (copyboard cover) open/close sensor and the contact sensor home position sensor are sent
out to the image processor PCB via the analog processor PCB.

3.1.9 Laser Driver/BD PCB

The image signals (VD0, VD0*) from the image processor PCB is converted into data used for laser adjustment (to
cause the laser diode to emit a laser beam). Also, the generated laser beam is detected, and the laser beam detection
signal (BDI*) is sent to the DC controller PCB.

3.1.10 Main Motor/Scanner Motor Driver

The main motor/scanner motor is driven according to the drive signals from the DC controller PCB.

3.1.11 Printer Controller PCB

The communications with the PC are controlled. The image data from the PC is converted into print data for the
machine, and is sent to the image processor PCB.
Chapter 3
0006-2855
0006-2857
0006-2858
0006-2860
0006-2861
0006-2862
0006-2863
3-5