Cinema Projector Led Status Indicators; Work With The Lamp; Adjust Lamp Power; Change The Lamp Power Percentage - Christie CP2220 User Manual

Section 5: Operation
5.4

Cinema Projector LED Status Indicators

Red, yellow, and green LEDs on the top and rear corners of the cinema projector indicate the status of the
cinema projector. The LEDs can be solidly lit, or they can flash frequently or intermittently. This table lists the
LED state and its associated meaning.
Table 5.1 cinema projector Status LED Legend
LED
Solid Green
Green Blip
Solid Yellow
Yellow Blip/
Green Blip
Flashing Red
Solid Red
5.5

Work with the Lamp

This section provides information and procedures for optimizing lamp performance. Optimizing lamp
performance can ensure you receive the brightest, most uniform image possible for the life of the lamp.

5.5.1 Adjust Lamp Power

1. Tap Menu > Advanced Setup > Lamp Power/LiteLOC Setup
2. Increase or decrease the Power % value.
3. Tap Set Target.
4. Select Enable LiteLOC™.

5.5.2 Change the Lamp Power Percentage

Entering a new Lamp Power percentage temporarily disables LiteLOC settings.
1. Tap Menu > Advanced Setup > Lamp Power/LiteLOC Setup.
2. Increase or decrease the Power % value.
5.5.3 Use LampLOC
To ensure optimal lamp performance and peak brightness at the screen for the life of the lamp, use LampLOC
to adjust the lamp position when you install a new lamp in the cinema projector. After making the adjustment,
the lamp is well-centered and distanced correctly from the remainder of the illumination system. Before
adjusting LampLOC
• The lamp must be ON and the douser (shutter) OPEN during adjustment. A 10-minute warm-up is recom-
mended. Ensure to follow all the criteria specified in
5-2
State
Lamp ON
Power ON
Standby mode
Cool down mode
New critical alarm or warning
Existing critical alarm or warning
™ to Adjust the Lamp Position
, ensure the following criteria are met:
™
Description
Power is ON, Lamp is ON.
Power is ON, Lamp is OFF. The lamp can be struck when in
this mode.
Power is OFF, Lamp is OFF. Power saving mode.
Transitioning to STANDBY mode.
Power is ON, Lamp is OFF.
The lamp can be struck when in this mode.
New critical alarm or warning has NOT been acknowledged
by operator.
Critical alarm or warning exists, but has been acknowledged
by operator.
.
5.1 Turn the Cinema Projector
™
On.
CP2220 User Manual
020-100420-08 Rev.1 (5-2014)