Set Ip Dscp - Edge-Core ES3510MA-DC Management Manual

| Quality of Service Commands
C 37
HAPTER

set ip dscp

C U
OMMAND SAGE
◆ The set cos command is used to set the CoS value in the VLAN tag for
matching packets.
The set cos and set phb
◆
priority. Therefore setting either of these commands will overwrite any
action already configured by the other command.
E
XAMPLE
This example creates a policy called "rd-policy," uses the
specify the previously defined "rd-class," uses the set cos command to
classify the service that incoming packets will receive, and then uses the
police flow command to limit the average bandwidth to 100,000 Kbps, the
burst rate to 4000 bytes, and configure the response to drop any violating
packets.
Console(config)#policy-map rd-policy
Console(config-pmap)#class rd-class
Console(config-pmap-c)#set cos 3
Console(config-pmap-c)#police flow 10000 4000 conform-action transmit
violate-action drop
Console(config-pmap-c)#
This command modifies the IP DSCP value in a matching packet (as
specified by the match
classification.
S
YNTAX
[no] set ip dscp new-dscp
new-dscp - New Differentiated Service Code Point (DSCP) value.
(Range: 0-63)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Policy Map Class Configuration
– 890 –
command function at the same level of
command). Use the no form to remove this traffic
class command to