Blank Margin; Registration Buckle Adjustment - Ricoh B064 Service Manual

COPY IMAGE ADJUSTMENTS: PRINTING/SCANNING

Blank Margin

NOTE: If the leading edge/side-to-side registration cannot be adjusted within
specifications, adjust the leading/left side edge blank margin.
1. Check the trailing edge and right edge blank margins, and adjust them with the
following SP modes.
SP2101 Print Erase Margin
Leading Edge
Trailing Edge
Left edge
Right edge

Registration Buckle Adjustment

When the customer is using special paper, buckle adjustment may be required if
paper feed problems arise.
• If the buckle is too large, this can cause wrinkling, creasing, or Z-fold jams
caused by sheets overtaking the sheets ahead of them in the paper path.
• If the buckle is too small, this can cause jams at the registration roller or skew
during paper feed.
1. Enter the SP mode.
2. Open SP1003.
• To prevent wrinkling, creasing, or Z-fold jams, set a smaller value.
• To prevent jams at the registration roller or to eliminate skew, set a larger
value.
SP1003-001
SP1003-002
SP1003-003
Adjustment range
Initial value
B064/B140 Series/G126
SP mode Specification
SP2101-001
2.5±2 mm
SP2101-002
SP2101-003
2±1.5 mm
SP2101-004
A: Trailing edge blank margin
B: Right edge blank margin
C: Leading edge blank margin
D: Left edge blank margin
Registration Buckle Adjustment – Tray, LCT
Registration Buckle Adjustment – Duplex Tray
Registration Buckle Adjustment – By-pass Tray
-9 mm ~ +9 mm (small ~ large buckle)
0 mm (Buckle = 10 mm)
3-144
D
C
B
B140R888.WMF
A
SM