Lexmark Pro700 Series
Encoder dial sensor removal
1. Remove the duplex/media sensor.
2. Remove the ADF/scanner assembly. See
3. Remove the midframe. See
4. Remove the system board. See
5. Remove the print engine. See
6. Remove the carrier assembly. See
7. Disconnect the cable (A), and remove the screw (B).
8. Lift the encoder dial sensor, and remove.
4-34
Service Manual
"Duplex/media sensor removal" on page
"ADF/scanner assembly removal" on page
"Midframe/INA card removal" on page
"System board removal" on page
"RFID card removal" on page
"Carrier assembly removal" on page
A
4-3.
4-4.
4-13.
4-21.
4-20.
4-29.
B