3.3
Removing and installing front left vehicle
level sender -G78-
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1410-
Removing
Note
To remove front left vehicle level sender -G78- , steering must be
turned to right lock to ensure clearance between suspension link
and anti-roll bar.
– Separate connector.
– Remove bolt and nut.
– Take out vehicle level sender.
Installing
Install in reverse order. Note the following points:
Note
Lever on vehicle level sender must face towards outside of
♦
vehicle.
Thread of vehicle level sender must be screwed into front hole
♦
in suspension link. Lug of bracket for vehicle level sender must
engage in rear hole in order to guarantee correct installation
position.
– Perform basic setting of headlights ⇒ "Guided fault-finding"
function of vehicle diagnostic, testing and information system
VAS 5051
Specified torques
Component
Bolt on subframe
Nut
♦ Use new nut
Golf 2004 ➤ , Golf Plus 2005 ➤
Running gear, axles, steering - Edition 08.2009
Specified torque
3. Subframe, anti-roll bar, suspension link
9 Nm
9 Nm
15