Volkswagen 2004 Golf Workshop Manual page 170

Golf 2004 ➤ , Golf Plus 2005 ➤
Running gear, axles, steering - Edition 08.2009
– Remove backplate.
– Remove bolt -arrow- for lower transverse link -1-.
Pressing out bonded rubber bush
– Attach tools as shown in figure.
1 - Nut -3346/3-
2 - Thrust piece -3301-
3 - Tube -3301/3-
4 - Drift sleeve -41 - 501-
5 - Thrust piece -3350/1-
6 - Spindle -3346/2-
– Pull out bonded rubber bush by tightening spindle.
Pulling in bonded rubber bush
– Attach tools as shown in figure.
1 - Nut -3346/3-
2 - Thrust piece -3301-
3 - Press tool -30 - 506 B-
4 - Bonded rubber bush
5 - Sleeve -3160-
6 - Thrust piece -3350/2-
7 - Spindle -3346/2-
– Pull in bonded rubber bush by turning spindle.
Note
Do not use lubricant.
♦
Install bonded rubber bush carefully so that it does not cant.
♦
Installing
– Install backplate.
– Install wheel bearing/wheel hub unit.
Bolt connections on wheel bearing housing may be tightened only
when dimension "a" has been obtained
162
Rep. Gr.42 - Rear suspension
⇒ page 137 .