Volkswagen 2004 Golf Workshop Manual page 221

9 - Lower transverse link
❑ Removing and installing
10 - Nut
❑ M12 x 1.5
❑ 90 Nm + 90° further
❑ Self-locking
❑ Always renew after removing
❑ Always tighten threaded connections in unladen position
11 - Bolt
❑ Always renew after removing
12 - Threaded rivet
❑ M6
13 - Spreader rivet
14 - Stone deflector
15 - Bolt
❑ 8 Nm
16 - Nut
❑ M14 x 1.5
❑ 130 Nm + 90° further
❑ Self-locking
❑ Always renew after removing
❑ Always tighten threaded connections in unladen position
17 - Bolt
❑ Always renew after removing
❑ Always tighten threaded connections in unladen position
18 - Upper transverse link
❑ Removing and installing
19 - Washer
20 - Nut
❑ M14 x 1.5
❑ 130 Nm + 90° further
❑ Self-locking
❑ Always renew after removing
21 - Wheel bearing housing
❑ Removing and installing
❑ Installing with wheel bearing housings made from aluminium is permissible ⇒ Electronic parts catalogue
"ETKA"
❑ Only wheel bearing housings made from aluminium are available as replacement parts. Therefore, cer‐
tain parts have to be exchanged and/or installed in addition when replacing
22 - Washer
23 - Bolt
❑ Always renew after removing
❑ Always tighten threaded connections in unladen position
24 - Track rod
❑ Closed in direction of travel
25 - Bolt
❑ Always renew after removing
11. Assembly overview - control arm, track rod (four-wheel drive, subframe made from aluminium and wheel bearing housing made from
Running gear, axles, steering - Edition 08.2009
⇒ page 217
⇒ page 215
⇒ page 236
Golf 2004 ➤ , Golf Plus 2005 ➤
⇒ page 187
⇒ page 187
⇒ page 187
⇒ page 235
⇒ page 187
213
cast steel)