Volkswagen 2004 Golf Workshop Manual page 275

– Now strap vehicle to the lifting platform arms on both sides of
the vehicle using tensioning straps -T10038- .
WARNING
If the vehicle is not strapped down there is a great danger that
the vehicle will slip off the lifting platform!
– Attach support -T10149- to wheel hub using wheel bolt.
– Raise wheel hub with support -T10149- and engine and gear‐
box jack -V.A.G 1383 A- far enough that bolts of right anti-roll
bar clamp are accessible.
Continuation for both sides of vehicle:
– Remove anti-roll bar.
Installing
– Install anti-roll bar in vehicle.
– Evenly tighten bolts -arrows- for anti-roll bar clamp.
For the right side of the vehicle only (depending on equipment)
– Lower wheel suspension again using engine and gearbox jack
-V.A.G 1383 A- and remove support -T10149- from wheel hub.
– Remove tensioning strap -T10038- .
Continuation for both sides of vehicle:
– Connect coupling rod -2- to anti-roll bar and tighten nut -1-.
– Install wheel and tighten.
Specified torques
Component
Anti-roll bar to subframe
♦ Use new bolts!
♦ Tighten threaded connections only when vehicle is in
the normal running position
17. Assembly overview - anti-roll bar (four-wheel drive, subframe made from aluminium and wheel bearing housing made from cast steel)
⇒ page 288
Golf 2004 ➤ , Golf Plus 2005 ➤
Running gear, axles, steering - Edition 08.2009
Specified torque
25 Nm + 90° further
267