Volkswagen 2004 Golf Workshop Manual page 305

– Turn wheel on tyre fitting unit so that tyre valve/ tyre pressure
sensor -2- is directly in front of assembly head -1-.
Caution
The assembly head -1- must never be within area -a- of tyre
valve/tyre pressure sensor, or the assembly head will damage
the tyre pressure sensor .
– Position assembly head -1- near tyre valve/ tyre pressure sen‐
sor so that an assembly lever can be inserted approx. 30° next
to the tyre valve/ tyre pressure sensor -2-.
– Seat depressor -3- on wheel rim opposite assembly head
-1-.
– Now lever tyre bead over assembly finger on assembly head
using assembly lever then remove assembly lever.
– Run tyre fitting machine clockwise until upper bead lies com‐
pletely above wheel rim flange.
This action will push the depressor -1- up against the assembly
head. This allows it to be removed easily.
– Turn wheel on tyre fitting unit so that tyre valve/ tyre pressure
sensor -2- is directly in front of assembly head -1-.
Caution
The assembly head -1- must never be within area -a- of tyre
valve/tyre pressure sensor, or the assembly head will damage
the tyre pressure sensor .
– Position assembly head -1- near tyre valve/ tyre pressure sen‐
sor so that an assembly lever can be inserted approx. 30° next
to the tyre valve/ tyre pressure sensor -2-.
– Now lever tyre bead over assembly finger on assembly head
using assembly lever -3-.
– Additionally insert a plastic assembly lever -4-.
– Remove assembly lever -3-.
Golf 2004 ➤ , Golf Plus 2005 ➤
Running gear, axles, steering - Edition 08.2009
5. Removing and fitting tyres with run-flat capability to wheel rims
297