Volkswagen 2004 Golf Workshop Manual page 205

– Set up special tools as shown in figure.
1 - Nut -T10263/5-
2 - Washer (commercial type)
3 - Subframe
4 - Tube -T10263/1-
5 - Hydraulic press -VAS 6178-
6 - Washer (commercial type)
7 - Nut -T10263/5-
8 - Spindle -T10263/4-
– Take up play in special tools.
– Pull out bonded rubber bush by actuating pump.
Pulling in front or rear bonded rubber bush
Install in reverse order. In the process, note the following:
The front and rear bonded rubber bushes differ slightly in height.
When installing, ensure the correct allocation ⇒ Electronic parts
catalogue "ETKA" .
The bonded rubber bush must be installed in a certain direction;
note mark on subframe.
– Set up special tools with bonded rubber bush on subframe as
shown.
WARNING
Thrust piece -T10263/3- must be positioned so that lugs on
bonded rubber bush align with free aperture on thrust piece -
T10263/3- .
1 - Nut -T10263/5-
2 - Washer (commercial type)
3 - Thrust piece -T10263/3-
4 - Subframe
5 - Bonded rubber bush
6 - Thrust piece -T10263/2-
7 - Hydraulic press -VAS 6178-
8 - Washer (commercial type)
9 - Nut -T10263/5-
10 - Spindle -T10263/4-
– Take up play in special tools and bonded rubber bush.
– Operate pump to carefully pull bonded rubber bush in until
collar lies "flush" on subframe.
– Perform wheel alignment ⇒ page 305 .
9. Assembly overview - subframe made from aluminium, final drive (four-wheel drive)
Golf 2004 ➤ , Golf Plus 2005 ➤
Running gear, axles, steering - Edition 08.2009
197