Adjusting Toe At Rear Axle - Volkswagen 2004 Golf Workshop Manual

– Tighten nut -A-.
– Use socket (18 mm) -T10179-
– Check camber value again after tightening nut -A-.
Specified torques
Component
Upper transverse link to subframe (vehicles with front-
wheel drive)
♦ Use new nut
♦ Tighten threaded connections only when vehicle is in
the normal running position.
Upper transverse link to subframe (vehicles with front-
wheel drive)
♦ Use new nut
♦ Tighten threaded connections only when vehicle is in
the normal running position
8.9

Adjusting toe at rear axle

Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1332-
Golf 2004 ➤ , Golf Plus 2005 ➤
Running gear, axles, steering - Edition 08.2009
Specified torque
♦ To tighten nuts, set torque wrench -V.A.G
1332- to 80 Nm
♦ Applies only in conjunction with insert tool,
18 mm -T10179-
♦ To tighten nuts, set torque wrench -V.A.G
1332- to 80 Nm
♦ Applies only in conjunction with insert tool,
18 mm -T10179-
95 Nm
95 Nm
315
8. Wheel alignment