Golf 2004 ➤ , Golf Plus 2005 ➤
Running gear, axles, steering - Edition 08.2009
– Attach tools as shown in figure.
1 - -3346/3-
2 - -3301-
3 - -30-506 B-
4 - Bonded rubber bush
5 - -3160-
6 - -3350/2-
7 - -3346/2-
– Pull in bonded rubber bush by turning spindle.
Note
Do not use lubricant.
♦
Install bonded rubber bush carefully so that it does not cant.
♦
Installing
Carry out installation in the reverse sequence, noting the follow‐
ing:
The threaded connections on the wheel bearing housing may be
tightened only when the dimension measured between the centre
of wheel hub and lower edge of wheel housing before work was
started has been attained
Specified torques
Component
Wheel bearing housing to lower suspension link
♦ Use new nuts and bolts
♦ Tighten threaded connections only when vehicle is in
the normal running position.
Splash plate to wheel bearing housing
Brake disc to wheel bearing housing.
13.4
Removing and installing wheel bearing/
wheel hub unit
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1332-
242
Rep. Gr.42 - Rear suspension
⇒ page 188
.
Specified torque
90 Nm + 90°
10 Nm
4 Nm