Volkswagen 2004 Golf Workshop Manual page 216

Hide thumbs Also See for 2004 Golf:
Table of Contents

Advertisement

Golf 2004 ➤ , Golf Plus 2005 ➤
Running gear, axles, steering - Edition 08.2009
Distinguishing features of bonded rubber bushes
I - Front bonded rubber bush
II - Rear bonded rubber bush
The front bonded rubber bushes have two notches on the upper
side -arrows- and differ to the rear slightly in height ⇒ Electronic
parts catalogue "ETKA" .
The bonded rubber bush must be installed in a certain direction;
note mark on subframe.
– Insert bonded rubber bush -1- in subframe so that the nose
and the plate -arrows- face perpendicular to direction of travel.
– Apply thrust piece -T10263/3- -2- so that flattened sides also
face perpendicular to direction of travel.
– Insert special tools with bonded rubber bush into subframe as
shown.
1 - Nut -T10263/5-
2 - Thrust piece -T10263/3-
3 - Bonded rubber bush
4 - Thrust piece -T10263/2-
5 - Hydraulic press -VAS 6178- and thrust piece -T10205/13-
6 - Nut -T10263/5-
7 - Spindle -T10263/4-
– Pre-tension special tools with bonded rubber bush.
– By actuating the pump, carefully draw bonded rubber bush in
until collar lies "flush" on subframe.
– Install track rods
⇒ page 231
– Install anti-roll bar
⇒ page 265
– Join electrical connections between rear axle and body.
– Install rear silencer of exhaust system ⇒ Rep. Gr. 26 ; Exhaust
system; Removing and installing parts of the exhaust system .
– Install coil springs
⇒ page 257
– Fit rear wheels.
Pulling out rear bonded rubber bush
– Remove rear wheels.
– Removing coil spring
– Remove rear exhaust system silencer ⇒ Rep. Gr. 26 ; Ex‐
haust system; Removing and installing parts of the exhaust
system .
208
Rep. Gr.42 - Rear suspension
.
.
.
⇒ page 257
.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents