Removing And Installing Lower Transverse Link - Volkswagen 2004 Golf Workshop Manual

Component
Upper transverse link to subframe
♦ Use new nut
♦ Tighten threaded connections only when vehicle is in
the normal running position.
11.4 Removing and installing lower trans‐
verse link
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1332-
Removing
– Remove wheel.
– Remove coil spring
– Remove bolt -arrow- for lower transverse link -1-.
Vehicles with dynamic headlight range control
11. Assembly overview - control arm, track rod (four-wheel drive, subframe made from aluminium and wheel bearing housing made from
⇒ page 257 .
Golf 2004 ➤ , Golf Plus 2005 ➤
Running gear, axles, steering - Edition 08.2009
Specified torque
♦ To tighten nuts, set torque wrench -V.A.G
♦ Applies only in conjunction with insert tool,
95 Nm
1332- to 80 Nm.
18 mm -T10179-
cast steel)
217