Removing And Installing Wheel Bearing Housing - Volkswagen 2004 Golf Workshop Manual

Hide thumbs Also See for 2004 Golf:
Table of Contents

Advertisement

12 - Bolt
❑ 4 Nm
13 - Brake disc
14 - Grease cap
❑ Always renew after removing
❑ Pressing off and driving in
A proper seal can be achieved only by installing a new grease cap.
15 - Bolt
❑ M16 x 1.5 x 70
❑ 180 Nm +180° further
❑ Loosen and tighten with bit XZN 18 -T10162-
❑ Always renew after removing
16 - Wheel hub with wheel bearing
❑ ABS sensor ring is installed in wheel bearing.
❑ Removing and installing
The wheel bearing and wheel hub are assembled one housing.
This wheel bearing/wheel hub unit is maintenance-free and has zero play. Adjustments and repairs are not
possible!
17 - Bolt
❑ 12 Nm
18 - Backplate
4.1
Removing and installing wheel bearing
housing
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1332-
Removing
– Remove wheel.
– Remove coil spring
– Remove wheel bearing/wheel hub unit
– Remove backplate.
– Remove ABS speed sensor out of wheel bearing housing.
⇒ page 164
⇒ page 164
⇒ page 173
.
⇒ page 164
4. Assembly overview: wheel bearing housing, trailing arm (front-wheel drive)
Golf 2004 ➤ , Golf Plus 2005 ➤
Running gear, axles, steering - Edition 08.2009
.
157

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents