Volkswagen 2004 Golf Workshop Manual page 352

Golf 2004 ➤ , Golf Plus 2005 ➤
Running gear, axles, steering - Edition 08.2009
– Fit universal joint -2- onto steering box pinion and tighten bolt
-1-.
– Install footwell trim -1- and secure with nuts -arrows-.
– Install cable duct -1- below steering column.
The lugs -arrow- must engage in the guide on both sides.
– Join connector -1-.
– Install footwell vent below steering column ⇒ Heating, air con‐
ditioning; Rep. Gr. 80 ; Repairing heating .
– Install steering column switch ⇒ Electrical system; Rep. Gr.
94 ; Steering column switch; Removing and installing steering
column switch .
– Install steering column switch trim ⇒ General body repairs,
interior; Rep. Gr. 68 ; Compartments, covers and trims; Re‐
moving and installing steering column trim .
– Install left trim on driver side ⇒ General body repairs, interior;
Rep. Gr. 68 ; Compartments, covers and trims; Removing and
installing left driver side trim .
– Install steering wheel
– Install airbag in steering wheel ⇒ General body repairs, inte‐
rior; Rep. Gr. 69 ; Airbag; Removing and installing driver side
airbag unit .
– Perform basic settings for steering angle sensor -G85- using
vehicle diagnosis, testing and information system -VAS
5051B- .
344
Rep. Gr.48 - Steering
⇒ page 336 .