Removing The Apg Assy; Reinstalling The Apg Assy; Phase Matching - Epson Stylus Photo R1800 Service Manual

EPSON Stylus Photo R1800/R2400
4. Remove the three C.B.S. M3 x 6 screws that secure the APG Assy, and
remove the APG Assy from the Main Frame.
1
2
Figure 4-46. Removing the APG Assy
When installing the APG Assy, make sure that the FLAG
Release Assy is not in a released state (Upper Paper
Guide down).
Upper Paper Guide
Released
Figure 4-47. Reinstalling the APG Assy
Disassembly And Assembly
2) C.B.S. 3x6
(8±1 kgf.cm)
3
FLAG Release Assy.
Not Released
Match the phase of the APG Assy in the following
procedure.
1.Match the delta marks of Spur Gear 16 and
Combination Gear 22, 28.8, 32.4.
Combination Gear,
22, 28.8, 32.4
2.At the position where the Tab can be identified through
the notch of the PG Frame, match the delta marks of
Spur Gear 16 and PG Cam (Left).
Tighten the screws in the order shown in
Disassembly
Delta Marks
Spur Gear 16
Spur Gear 16 PG Cam (Left)
Tab
Delta Marks
Figure 4-48. Phase Matching
Revision B
Figure 4-46.
94