Epson Stylus Photo R1800 Service Manual page 151

EPSON Stylus Photo R1800/R2400
2. Connect the printer to the PC by a USB cable, and click [Next].
Figure 5-24. Checking the Printer Connection
3. The printer driver for Stylus Photo R1800 is automatically detected, and
the USB ID is automatically acquired.
The remaining amount of the ink is checked before the
C A U T I O N
USB ID is acquired. If there is an ink cartridge(s) with a
remaining amount of ink of 30% or less (ink low/ink out
states), a warning message is displayed.
As the USB ID is used to recognize printers when
entering color measurement values, do not change the
USB ID after performing the Colorimetric Calibration.
Only printers connected with USB are recognized.
C H E C K
P O I N T
When two or more printers are currently connected, the
screen changes to the "port selection" screen.
Figure 5-25. Selecting the Port
Adjustment
4. To prevent inks from settling down at the bottom, remove all ink cartridges,
shake them at least four times, and reinstall them to the printer.
5. To prevent inks from settling down at the bottom, cleaning cycles shown
below are performed.
Exchange CL (once) + CL3 (once)
Adjustment
Figure 5-26. Ink Setup
Figure 5-27. Cleaning
Revision B
Warning
message
151