Screws That Secure The Printer Mechanism; Installing The Ink Tubes - Epson Stylus Photo R1800 Service Manual

EPSON Stylus Photo R1800/R2400
1) C.B.P. 3x10
(6±1 kgf.cm)
Printer Mechanism
4
3
1) C.B.P. 3x10
(6±1 kgf.cm)
5
Lower Housing
Figure 4-12. Screws that Secure the Printer Mechanism
Disassembly And Assembly
Ink Tubes
Fastener
Step 2
Waste Ink Tubes
3) C.B.S. (P2)
3x10
6
130 Digit Side Waste Ink Tube
1
2
0 Digit Side Waste Ink Tube
A D J U S T M E N T After replacing the Printer Mechanism, be sure to make the
R E Q U I R E D
following adjustments.
1. Platen Gap (PG) Adjustment
2. Ink Mark Sensor Adjustment
3. Head Angular Adjustment
4. Auto Bi-D Adjustment
Fastener
5. Ink Mark Sensor Adjustment
6. First dot position
7. PW Sensor Adjustment
8. PF Deterioration Compensation Counter Reset
9. PF Adjustment
10. PF Adjustment (Bottom Margin)
11. CR Motor Drive Dispersion Measurement Sequence
Refer to Chapter 5 "Adjustment" for details of the
adjustments.
Disassembly
Insert the Waste Ink Tube with the red line into the lower
Ink Tube.
130 Digit Side Ink Tube
0 Digit Side Ink Tube
Figure 4-13. Installing the Ink Tubes
Make sure that the Waste Ink Tubes are not nipped by
the Printer Mechanism.
Tighten the screws in the order shown in
Revision B
Figure 4-12.
79