Reinstalling The Asf Assy.; Raising The Hopper - Epson Stylus Photo R1800 Service Manual

EPSON Stylus Photo R1800/R2400
Align the Guide Pin and four Tabs on the ASF Assy with
the positioning holes on the Main Frame so that there is
no gap between the ASF Assy and the Main Frame.
Tab
Figure 4-24. Reinstalling the ASF Assy.
Tighten the screws in the order shown in
Disassembly And Assembly
Guide Pin
Tab
Tab
Tab
Figure 4-23.
Adjusting the Position of the ASF Guide Roller LDs
When installing the Guide Roller LDs, the position of the
Guide Roller LDs must be adjusted so that the positions
of the LD Roller Shaft and Retard Roller are optimized in
order to maintain the paper feed accuracy.
1. After installing the ASF Assy, loosen the two C.B.S.
M3 x 6 screws that secure the Guide Roller LD.
to Figure 4-22.
2. Turn Combination Gear 29.11 on the right side of the
ASF Assy CCW to raise the Hopper to the upper limit
position (until the Hopper Pad contacts the LD
Roller).
Combination Gear 29.11
Hopper Pad
Disassembly
LD Roller
Figure 4-25. Raising the Hopper
Revision B
Refer
85