Epson Stylus Photo R1800 Service Manual page 214

EPSON Stylus Photo R1800/R2400
Occurrence
Phenomenon Detail
Timing
At operation When feeding a Board
Paper, an error is displayed
on the LED and EPW3.
Occurrence
Phenomenon Detail
Timing
At operation or A message is displayed on
during printing the LED and EPW3 during
printing.
Occurrence
Phenomenon Detail
Timing
During printing After the Carriage has
detected the HP, an error is
displayed on the LED and
EPW3.
Stylus Photo R2400
Table 8-11. Troubleshooting of Paper Mismatch Error
Faulty Part/Part
Name
Paper EJ Frame 1. Check if the CD-R Tray Base(Board Tray Base) is closed
Assy or not.
CD-R Sensor 1. Check that the Connector cable of the CD-R Sensor is
(Board Sensor) securely connected to the connectors of the CD-R Sensor
and Panel Board.
CD-R Sensor
Connector cable of
the CD-R Sensor
2. Check the CD-R Sensor(Board Sensor) or Connector
cable for damages.
Table 8-12. Troubleshooting of Ink Low
Faulty Part/Part
Name
Ink Cartridge 1. Look at the remaining ink indication of the EPW3 to check
the amount of the ink remaining in the Ink Cartridge.
Table 8-13. Troubleshooting of Ink Out Error
Faulty Part/Part
Name
Ink Cartridge 1. Look at the remaining ink indication of the EPW3 to check
whether the ink remains in the Ink Cartridge.
Overview
Check Point
Panel Board connector
Check Point
Check Point
Revision B
Remedy
1. Open the CD-R Tray Base(Board Tray
Base) .
1. Connect the Connector cable of the CD-R
Sensor (Board Sensor) to the CD-R
Sensor(Board Sensor) and Panel Board
Connectors.
2. Replace the CD-R Sensor(Board Sensor)
with a new one.
Remedy
1. Prepare a new Ink Cartridge.
Remedy
1. Replace the Ink Cartridge with a new one.
214