Epson Stylus Photo R1800 Service Manual page 210

EPSON Stylus Photo R1800/R2400
Occurrence
Phenomenon Detail
Timing
At operation Though paper is fed from the
ASF Assy, it stops near the PE
Sensor Lever.
Stylus Photo R2400
Table 8-8. Troubleshooting of Paper Out Error
Faulty Part/
Part Name
PE Sensor 1. Check that the Connector cable of the PE Sensor is
securely connected to the PE Sensor and Relay Board
Connector CN2.
PW Sensor Connector
2. Check that the Sensor Holder is mounted to the
Mechanical frame correctly.
Sensor Holder
Detection Lever
Torsion Spring
3. Move the Detection Lever manually as when the paper
passes, and check that the Detection Lever returns to the
original position automatically by the Torsion Spring when
released. Refer to the above photo.
4. Using a tester, check that the PE Sensor is normal.
⋅ Paper absent : 2.4V or more
⋅ Paper present : 0.4V or less
Overview
Check Point
CN2
Revision B
Remedy
1. Connect the Connector cable of the PE
Sensor to the PE Sensor and Relay Board
Connector CN2.
2. Install the Sensor Holder correctly.
3. Replace the PE Sensor Holder Unit with a
new one.
4. Replace the PE Sensor Holder Unit with a
new one.
210