EPSON Stylus Photo R1800/R2400
4.2.6.8 Ink System Unit
1. Remove the Right CD-R Release Lever SubAssy.
page 106.
2. Release the Carriage lock, and move the Carriage Unit to the center.
Section 4.2.1.3 on page 75.
3. Remove the C.B.S. M3 x 8 screw that secures the Earth Cable to remove
the Earth Cables, and untie the Earth Cable from the Relay Connector
Cable.
4. Disconnect the Pump Motor Connector from the Relay Connector.
5) C.B.S. 3x8
(8±1 kgf.cm)
Earth Cable
Relay Connector Cable
Figure 4-95. Disconnecting the Pump Motor Connector
Be sure to screw the two Earth Cables together.
Referring to
Figure
Connector Cable.
Disassembly And Assembly
See Section 4.2.6.7 on
Relay Connector
4-95., correctly route the Relay
5. Remove the two C.B.S. M3 x 4 screws that secure the Ink System Guide
Plate, and remove it.
See
2
Ink System
Guide Plate
10) C.B.S. 3x4
(8±1 kgf.cm)
Figure 4-96. Removing the Ink System Guide Plate
Align the notch on the Ink System Guide Plate with the
notch on the Main Frame.
Figure 4-97. Reinstalling the Ink System Guide Plate
Tighten the screws in the order shown in
Disassembly
Revision B
1
Figure 4-96.
109