Removing Left Pg Torsion Spring; Removing Right Pg Torsion Spring; Reinstalling Pg Torsion Springs; Removing Cr Shaft Mounting Plate Fixed Spring - Epson Stylus Photo R1800 Service Manual

EPSON Stylus Photo R1800/R2400
7. Remove the foot of Left PG Torsion Spring from Tab A, and remove the
coil section from Tab B to remove Left PG Torsion Spring from the Main
Frame.
Left PG Torsion Spring
Tab B
Figure 4-51. Removing Left PG Torsion Spring
8. Remove the foot of Right PG Torsion Spring from Tab A, and remove the
coil section from Tab B to remove Right PG Torsion Spring from the Main
Frame.
Tab A
Figure 4-52. Removing Right PG Torsion Spring
Disassembly And Assembly
Tab A
Right PG Torsion Spring
Tab B
Place the feet of Left PG Torsion Spring and Right PG
Torsion Spring on the Carriage Shaft.
Left Side
Figure 4-53. Reinstalling PG Torsion Springs
9. Remove CR Shaft Mounting Plate Fixed Spring from the Tab and Notch on
the Main Frame, and draw out the spring in the direction of the arrow.
Figure 4-54. Removing CR Shaft Mounting Plate Fixed Spring
Insert the foot of CR Shaft Mounting Plate Fixed Spring into
the notch on the Main Frame (rear side).
Disassembly
Right Side
Foot
Foot
CR Shaft Mounting Plate Fixed Spring
Tab
Notch
See Figure 4-54.
Revision B
Notch (rear side)
96