Cr Encoder Sensor Board; Pf Encoder Sensor Holder; Removing Cr Encoder Sensor Board; Removing Ffc And The Screw That Secures Pf Encoder Sensor Holder - Epson Stylus Photo R1800 Service Manual

EPSON Stylus Photo R1800/R2400

4.2.8.3 CR Encoder Sensor Board

1. Remove the Carriage Unit. See Section 4.2.6.4 on page 95.
2. Remove the two C.B.P. M2.6 x 5 screws that secure the CR Encoder
Sensor Board.
3. Disconnect the FFC of PW Sensor and Ink Mark Sensor from the
Connector on the CR Encoder Sensor Board, and remove the CR Encoder
Sensor Board.
13) C.B.P. 2.6x5
(3±0.5 kgf.cm)
CR Encoder
Sensor Board
Figure 4-140. Removing CR Encoder Sensor Board
Disassembly And Assembly

4.2.8.4 PF Encoder Sensor Holder

1. Remove the Upper Housing.
2. Disconnect the FFC from the PF Encoder Sensor Board.
3. Remove the C.B.S. M3 x 8 screw that secures the PF Encoder Sensor
FFC
Connector
Disassembly
See Section 4.2.1.4 on page 76.
Holder.
FFC
Connector
Figure 4-141. Removing the FFC and the Screw that Secures
the PF Encoder Sensor Holder
Revision B
PF Encoder Sensor Holder
5) C.B.S. 3x8
(6±1 kgf.cm)
126