Writing Of Color Id - Epson Stylus Photo R1800 Service Manual

EPSON Stylus Photo R1800/R2400
Be sure to start the measurement from the top side of the
C A U T I O N
chart.
Take more than 10 seconds to measure one row.
Slide the calibrator at a constant speed.
During color measurement, do not allow the Calibrator to
rub against unmeasured patches on the chart.
Prevent the ruler and Calibrator from coming off the
chart sheet during color measurement. Doing so will
cause incorrect color measurement.
During color measurement, measure only the patches on
the chart sheet. Do not measure other parts such as the
USB ID text string.
When there is an error possibility in measuring color, a
warning mark (
such case, make sure to measure the row that includes
the patch with a warning mark again.
If the number of scanned patches does not match the
number of patches on a single row, the cursor stops at
that row, the error mark (
patches on that row, and the following error message is
displayed:
•
"Color measuring by Eye-One calibrator has failed.
Measure colors of the failed row again."
Adjustment
) appears at the patch in question. In
) appears on all of the
13. Click [Next], and write the Color ID to the printer.
Figure 5-38. Writing of Color ID
It takes about three minutes to write the Color ID to the
C H E C K
P O I N T
printer.
Figure 5-39. Writing of Color ID in Progress
Adjustment
Revision B
156