EPSON Stylus Photo R1800/R2400
4.2.6.10 FLAG Release Assy.
1. Remove the APG Assy.
See Section 4.2.6.3 on page 93.
2. Remove the Release Holder Assy.
3. Remove the Guide Pin on the Driven Release Holder from the Main Frame
using tweezers, and slide the Driven Release Holder to the left as viewed
from the front of the Printer Mechanism.
In the following procedure, Parallel Pin 1.5 may drop off
C A U T I O N
when the Driven Release Holder is slid. Be careful not to
lose it.
Parallel Pin 1.5
Figure 4-107. Parallel Pin 1.5
Disassembly And Assembly
See Section 4.2.6.9 on page 112.
4. Release the three Tabs on the Driven Release Holder from the Main
Frame, and remove the FLAG Release Assy.
Front
Guide Pin
Rear
FLAG Release Assy.
Figure 4-108. Removing the FLAG Release Assy
Disassembly
Front
Tabs
Tab
Driven Release Holder
Tabs
Guide pin
Revision B
113