Removing The Motors; Cr Motor; Removing The Cr Motor Connector Cable - Epson Stylus Photo R1800 Service Manual

EPSON Stylus Photo R1800/R2400

4.2.7 Removing the Motors

4.2.7.1 CR Motor

1. Remove the Upper Housing. See Section 4.2.1.4 on page 76.
2. Release the Carriage lock, and move the Carriage Unit to the center.
Section 4.2.1.3 on page 75.
3. Disconnect the CR Motor Connector Cable from the Relay Connector.
CR Motor
CR Motor
Connector Cable
Relay Connector
Figure 4-130. Removing the CR Motor Connector Cable
4. Press the Driven Pulley toward the center to loosen the CR Drive Belt, and
remove the CR Drive Belt from the CR Motor Pinion Gear.
CR Drive Belt
Driven Pulley
Disassembly And Assembly
See
CR Motor Pinion Gear
Disassembly
5. Remove the two C.B.S. M3 x 4 screws that secure the CR Motor, and
remove the CR Motor from the Main Frame.
10) C.B.S. 3x4
(4±0.5 kgf.cm)
Figure 4-131. Removing the CR Motor
Make the Lot No. printed surface on the CR Motor face
the direction shown in the figure below.
Figure 4-132. Reinstalling the CR Motor
Tighten the screws in the order shown in
A D J U S T M E N T Be sure to perform the following adjustments after replacing
R E Q U I R E D
the CR Motor.
CR Motor Drive Dispersion
Refer to Chapter 5 "Adjustment" for details of the
adjustments.
Revision B
2 1
Lot No. Printed Surface
Figure 4-131.
122