The Pf Roller Shaft And The Bushing Of The Front Paper Guide; Reinstalling The Front Paper Guide; Checking The Front Paper Guide Pad - Epson Stylus Photo R1800 Service Manual

EPSON Stylus Photo R1800/R2400
Align the Bushing of the Front Paper Guide with the PF
Roller Shaft.
Figure 4-119. The PF Roller Shaft and the Bushing of the
Align the positioning holes on the Main Frame with the
Guide Pins on the Front Paper Guide.
Guide Pins
Figure 4-120. Reinstalling the Front Paper Guide
Disassembly And Assembly
Shaft and Bushing
Front Paper Guide
After installing the Front Paper Guide, lift the Printer
Mechanism to check the following points.
1. Make sure that the Tabs on the Paper Guide Pad are not
cut midway.
2. Make sure that all Tabs are facing down (toward the
Waste Ink Pads) without any folds.
3. Make sure that the Tab foldbacks are protruding
completely from the Front Paper Guide.
Tabs
Figure 4-121. Checking the Front Paper Guide Pad
A D J U S T M E N T After replacing the following part, be sure to apply G-45 grease
R E Q U I R E D
to the area specified for each part.
EJ Grounding Spring
Front Paper Guide and Paper Eject Roller
on page 177.
A D J U S T M E N T Be sure to perform the following adjustments after the Front
R E Q U I R E D
Paper Guide and Paper eject roller are replaced or removed:
1. Ink Mark Sensor Adjustment
2. PW Sensor Adjustment
3. PF Adjustment
4. PF Adjustment (Bottom Margin)
Refer to Capter 5 "Adjustment" for details of the
adjustments.
Disassembly
Revision B
Tabs
See Figure 6-10 on page 177.
See Figure 6-11
118